Benutzer-Werkzeuge

Webseiten-Werkzeuge


wolf_en

Wolf

The Wolf driver allows it to transfer any data over the implemented Wolf protocol to Wolf heating and cooling devices.

The name of this driver is: wolf
The routing address of the first driver is: 1500
The data point file name for the first driver is: wolf1.txt
The driver configuration file name for the first driver is: wolf1.cfg

For the Wolf driver as well as all other gateway drivers the data point definitions are as follows:

Type Description
M Integer value (binary data points, counters) which can/shall only be read by the gateway
S Integer value which can be either read or written by the gateway. (to M-BUS writing is not possible)
X Floating point value (with decimal place) which can/shall only be read by the gateway
Y Floating point value (with decimal place) which can be either read or written by the gateway. (to M-BUS writing is not possible)
A String, is used e.g. with BACnet Trends and ESPA4.4.4 data points

The Wolf addresses are defined as follows:
<data point-type> <station-id>.<data point-id>

data point-type: failure, point
station-id: 0 - 255 (0 is the locale station of the driver)
data point-id: 0 - 65534

data point-type: "failure"

[M failure 0]
name = connection lost to station 0
query = pe

data point-type: "point"

[S point 0.1]
name = Error
query = pe
nomval = 0

[S point 0.2]
name = mode of operation
query = pe
nomval = 3

Start options of this driver in section [WOLF]:

Name: Type Range
IpAddrstring0.0.0.0
IpPortnumber0-65535


Options of this driver in section [STATION_<no>]:

Name: Type Range
IpAddrstring0.0.0.0
IpPortnumber0-65535


Example wolf1.cfg-file:

[WOLF]
IpAddr = 192.168.0.249
IpPort = 4000

[STATION_1]
IpAddr = 192.168.0.249
IpPort = 4096

[STATION_2]
IpAddr = 192.168.0.249
IpPort = 4097

Imprint/Impressum Disclaimer DSGVO/Privacy Policy

wolf_en.txt · Zuletzt geändert: 13.01.2022 21:21 von oni

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki