Benutzer-Werkzeuge

Webseiten-Werkzeuge


dali_en

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen gezeigt.

Link zu der Vergleichsansicht

Beide Seiten, vorherige Überarbeitung Vorherige Überarbeitung
dali_en [24.08.2018 14:48]
Frank Lahnor
dali_en [08.04.2019 15:39] (aktuell)
Patrick Pütter
Zeile 27: Zeile 27:
 ^<​shortaddress>​ \\ <​groupaddress> ​ |integer \\ integer ​ |Short address of device (0..63)\\ group address (0..15) | ^<​shortaddress>​ \\ <​groupaddress> ​ |integer \\ integer ​ |Short address of device (0..63)\\ group address (0..15) |
 ^<​value-type> ​ |switch \\ level \\ scene \\ gearfailure \\ \\ lampfailure \\ \\ failure ​  | 0=off, 1=on  state read/write \\ 0,​0%..100,​0% ​ Niveau (Light dimming) read/write \\ 1..16 scene read/write \\ In case device does not work. E.g. too low supply or over heating. \\ \\ In case the lamp cannot operate as expected e.g. improper cabelling, defect lamp \\ \\ if the device is unavailable| ^<​value-type> ​ |switch \\ level \\ scene \\ gearfailure \\ \\ lampfailure \\ \\ failure ​  | 0=off, 1=on  state read/write \\ 0,​0%..100,​0% ​ Niveau (Light dimming) read/write \\ 1..16 scene read/write \\ In case device does not work. E.g. too low supply or over heating. \\ \\ In case the lamp cannot operate as expected e.g. improper cabelling, defect lamp \\ \\ if the device is unavailable|
 +
 +The format can be used to manipulate the PollingTime from the dali1.cfg.
 +
 +format = <​format>​
 +
 +<​format>​ can take the following values:
 +
 +^<​format> ​ ^Description ​ ^
 +^T:0  |Value is not polled ​ |
 +^T:X  |X * PollingTime (from the dali1.cfg), the time, the value is be polled [ms]  |
 +
 +^
  
 The switch data point for LED with short address 10 at channel 1 is defined in file DALI1.TXT as follows:\\ The switch data point for LED with short address 10 at channel 1 is defined in file DALI1.TXT as follows:\\
dali_en.1535114913.txt.gz · Zuletzt geändert: 24.08.2018 14:48 von Frank Lahnor