Clino Opt 99

The Clino Opt driver allows reading values from a message center via RS-232 interface.

The name of the first Clino driver is: clino
The routing address of the first Clino driver is: 1330
The data point file of the first Clino driver is: clino1.txt
The configuration file for global settings of the first Clino driver is: clino1.cfg

The Clino Opt 925 driver following definitions for data points are valid.

Type	Description
M	Integer value (Binary data points, values) that can only be read by the gateway.
S	Integer value (Binary data points, values) that can only be read and written by the gateway.

Addresses are defined as follows:

„<type> <token>“

Parameter	Range of values	Description
<type>	state, cmd	Message from message center message to message center
<token>		Status/control function for state/cmd

The state of call will be stated in ClinoX.txt as follows:

[M state WAIT]

Status-Token

Token	Description
GESPR.	conversation
STOER.	failure call
AW1	Presence 1
AW2	Presence 2
WARTEN	waiting call
ESSEN	call for meal
PERSON	call for staff
TELEF.	telephone call
STECK.	connector failure call
NORMAL	standard call
BAD-WC	call from restroom
NOTBAD	emergency call from restroom
NOTRUF	emergency call
DIA	diagnostics call
PRIORI	priority call
ARZT	call doctor

Control function token

Token	Description
UHR	set clock

_{Imprint/Impressum
Disclaimer
DSGVO/Privacy Policy}